face recognition access control system < / a > installation steps of gate column

　　1. According to the requirements of the installation site, a hole with a diameter of 50mm shall be opened at the spatial position on the gate, generally in the middle or front

Note: the opening position shall be based on the actual application scenario and gate type, and 50cm is only the reference value

　　2. Unscrew the nut from the gate head column to the lower part, thread the cable out of the nut and gasket, and remove the nut and gasket

Note: do not connect the network cable and power cord at this time to avoid troublesome installation

　　3. Insert the gate head and cable into the gate opening from top to bottom

　　4. Under the gate, pass the cable and cable interface through the gasket and nut in turn, align the nut with the thread and tighten it

　　5. Connect the power supply and network cable, and the screen starts

　　6. Hold the column with both hands and rotate it gently to adjust the gate angle. Adjust the gate head to the appropriate identification angle according to the identification interface